This Flow Meter assembly is for 1/2 in. pipe only.
The transducer clamps on the pipe via a couple of wing nuts.
12 volt DC is supplied via the wall transformer.
Reset total and configuration (if necessary) via the PC cable that plugs in the serial port of a computer.
This Special Flow Meter is available for Sale or Rent.
Back to Flow Meter Overview Page
Special TXFL Flow Meter for 1/2 in. pipe.
Picture consists of the following:
Transmitter is mounted on a clear plastic plate with two holes on the top corners. The two holes are for a rope or string allowing the transmitter to hang on a hook, valve, nail, or screw. Rate and total show on the display on the transmitter. Wall transformer for power is on the lower right. Configuration (if necessary) is via the PC cable with RS232 connector shown above the wall transformer and your computer.. We can configure the Flow meter before it leaves our shop so all you have to do is put some silicon grease on the pipe, clamp it on the pipe, and plug the wall transformer into 110VAC. PC cable would then only be required if you wanted to reset the totalizer.
Transducer that clamps on the ½ inch pipe via a couple of wing nuts is on the upper left.